Canberra Granite & Marble Mitre Saw Service & Repairs

Canberra Industrial Machinery Service & Repairs - Carried out electrical maintenance and repairs on this FARNESE Granite & Marble Mitre Saw. Diagnosed electrical faults casing main saw cutting motor assembly not to travel left and right when cutting as intended. Replaced all associated faulty electrical switchgear to repair the electrical machine fault. Carried out general machine cleaning of all electrical switchgear within the main operators control panel.

Maintaining a granite mitre saw involves regular cleaning, blade care, lubrication, and proper storage. Keeping the saw clean, lubricating moving parts, and ensuring the blade is sharp and in good condition are crucial for optimal performance and safety. 

Here's a more detailed breakdown of required maintenance services that should be carried out regularly on your Marble & Granite Mitre Saws;

1. Regular Cleaning:

• After each use:

  Remove sawdust and debris to prevent build-up and ensure smooth operation. 

• Clean the blade:

  Wipe it down with a damp cloth, and for tougher grime, use a stone cleaning solution or a light abrasive pad, following manufacturer's recommendations. 

• Empty the dust collection system:

  Regularly empty the dust bag or canister, an

  d consider using a shop vac for a more thorough cleaning, especially around the carriage and rails. 

• Clean moving parts:

  Use a brush or compressed air to remove dust and debris from the saw's exterior and moving parts. 

2. Blade Care:

• Inspect regularly: Check for sharpness, damage, and cracks. 

• Sharpen or replace: If the blade is dull or damaged, sharpen or replace it to maintain cutting accuracy and safety. 

• Proper cleaning: Clean the blade thoroughly after each use and consider using a blade cleaner specifically designed for granite or stone. 

3. Lubrication:

• Lubricate moving parts:

  Apply lubricant to the moving parts of the saw, such as the pivot points and sliding mechanisms, to ensure smooth operation. 

• Refer to the manual:

  Consult the manufacturer's instructions for recommended lubricants and lubrication points. 

4. Storage:

• Store in a dry place: Protect the saw from moisture and humidity to prevent rust and corrosion. 

• Cover if necessary: Consider covering the saw when not in use to further protect it from dust and debris. 

5. Additional Tips:

• Inspect power cord and safety features:

  Regularly check for any damage to the power cord and ensure all safety features are functioning correctly before each use. 

• Calibrate the saw:

  Periodically check the alignment of the fence, bevel angles, and table to ensure accurate cuts. 

• Use proper safety gear:

  Always wear safety glasses, gloves, and hearing protection when operating the saw. 

• Follow manufacturer's instructions:

  Refer to the user manual for specific maintenance and safety instructions for your mitre saw. 

  
  

The team at CINCO special in Industrial Machine Service & Repairs. If your needing your Workshop Band Saw Machine serviced or repaired... Give the team at CINCO a call today and book your next machine service.

Call 0405 545 600 or email workflow@cincoelectrical.com.au